|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
(b) The simple bar pointer of ADF indicator is located at 90° to the right of the lubber line. With RMI KI 229 indicator (b) The simple bar pointer of RMI indicator is located at 90° to the right of the lubber line. With RMI KNI 582 indicator (b) The bar pointers of RMI indicator are located at 90° to the right of the lubber line. (a) "BFO" message appears. (b) A tone of 1 KHz sounds in the headset. ACTION RESULT (9) On the ADF receiver, set the "ADF" pushbutton in pushed-in position. (10) On the ADF receiver, momentarily press the "FLT/ET" pushbutton. (11) On the ADF receiver, momentarily press the "FLT/ET" pushbutton. (12) On the ADF receiver, momentarily press the "SET/RST" pushbutton. (13) On the ADF receiver, momentarily press the "SET/RST" pushbutton and hold it during two seconds. (14) When the "ET" message flashes, enter the duration 59 : 59 on the elapsed time counter with the concentric knobs. (a) "ADF" message appears. Aircraft with RMI KI 229 indicator (b) On the RMI, the dual bar pointer shows the bearing relative to the selected ADF station. Aircraft with ADF KI 227-00 indicator (b) On the ADF indicator, the single bar pointer shows the direction of the selected ADF station. Aircraft with ADF KI 227-01 indicator (b) On the ADF indicator, the single bar pointer shows the bearing relative to the selected ADF station. Aircraft with RMI KNI 582 indicator (b) On the RMI, the bar pointers show the bearing relative to the selected ADF station. (a) "FLT" or "ET" message appears. NOTE : If "ET" message appears, momentarily press the "FLT/ET" pushbutton. (b) "FLT" message appears (c) The R.H. display window shows the time elapsed since the ADF receiver energization. (a) "ET" message appears. (a) On the ADF receiver, the elapsed time counter is set to zero and the timing starts. (a) "ET" message flashes. (a) The R.H. display window shows 59 : 59. (a) The elapsed time counter starts the countdown. 20) Open main switch-breaker. 21) Disconnect the ground power unit - refer to 24-40-00. Ity : KR 87 - KR 87 SC+ 7AA Validity 504 (BA) JUN 04 E35 / E15 ADF ANTENNA MAINTENANCE PRACTICES 1. SERVICING None 2. REMOVAL / INSTALLATION - ADF ANTENNA (Figure 201) NOTE : This procedure applies to ADF1 and ADF2 installations. A. Tools and consumable materials - Sealant (TB 09-903) - Plastic scraper - Clean linffree cloths - Cleaning agent (TB 11-003) - Blanking caps and plugs B. Removal of ADF antenna 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 34 导航 TB20飞机维护手册 2(49) |
