曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
- the "PULL IDENT" button. When this button is pulled out, the identification code of the ground station sounds through A50 audio control panel. To adjust the audio level, rotate this button. When the "PULL/IDENT" button is pushed in, the identification code is attenuated,
AKAK
Validity : KX 155 - KX 155A with audio control panel 34 51 00Page 2
(DE) NOV 01
A - A51 VHF NAV/COMM. transceiver (KX 155)
B - A51 VHF NAV/COMM. transceiver (KX 155A)
C - Course deviation indicator (option) (VOR/ILS information)
D - Course deviation indicator (option) (VOR/LOC information)
NAV 1 installation - Identification and location of components
Figure 1
AKAK
Validity : KX 155 - KX 155A with audio control panel 34 51 00Page 3
(DE) NOV 01
A A - E34 GLIDE antenna (option or standard)
Ili B - E33 VOR/LOC antenna
C - A59 VOR signal separator (option)
D - A60 GS signal separator (option)
NAV 1 installation - Identification and location of components
Figure 2
AKAK
Validity : KX 155 - KX 155A with audio control panel 34-51-00Page 4
(DE) NOV 01
A - A95 VOR/LOC converter (option)
14345500AAAMWZ4000 NAV 1 installation - Identification and location of components
Figure 3
AKAK
Validity : KX 155 - KX 155A with audio control panel 34 51 00Page 5
(DE) NOV 01
- the "OFF/PULL TEST" button which energizes the VHF NAV/COMM transceiver. All
The VHF NAV/COMM. transceiver is electrically supplied by "BUS 1" bar via the radio master relay (if installed) and protected by CB 86 "COM/NAV 1" circuit breaker.
The VHF NAV/COMM. transceiver is mounted on the radio rack.
B. E33 VOR/LOC antenna
The "V" type VOR/LOC antenna consists of two radiants mounted horizontally on each side of the vertical stabilizer. It enables reception of signals within 108 MHz to 118 MHz frequency range.
C. E34 GS antenna
The GS antenna consists of two radiants mounted horizontally on each side of the vertical stabilizer. It enables reception of signals within 329 MHz to 335 MHz frequency range.
D. A59 VOR signal separator (option)
The signal separator is used to couple NAV 1 and NAV 2 installations with the VOR/LOC antenna. It consists of a rectangular box fitted with two attachment tabs. It features 3 BNC connectors.
It is mounted on the L.H. side of the radio rack.
E. A60 GS signal separator (option)
The signal separator is used to couple NAV 1 and NAV 2 installations with the GS antenna.
It consists of a rectangular box fitted with two attachment tabs. It features 3 BNC connectors. It is mounted on the R.H. side of the radio rack.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 34 导航 TB20飞机维护手册 1(83)
|
