曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
6) Remove E41 antenna (5). 7) Retain gasket (2). 8) If necessary, remove any sealant residues around the hole (7) of support. All 9) Blank off connector (1). 10) If necessary, remove any sealant residues on the antenna and the fuselage. C. Installation of E41 stormscope antenna 1) Make sure that the main switch-breaker is open. 2) Inspect gasket (2) for condition. Replace gasket if necessary. 3) Remove the blanking cap from connector (1). WA Validity : All WX 1000 - WX 500 series 34-41 Page 201 03 (BA) JUN 04 With WX 1000 series 4) Fit the antenna with screws (6), washers (4), MYLAR washers (3) and gasket (2). 5) Position E41 antenna (5) with the arrow pointing forwards. 6) Secure the antenna with screws (6). I 7) Connect connector (1). With WX 500 series 4) Fit the antenna with gasket (2). 5) Position E41 antenna (5) with the arrow pointing forwards. 6) Secure the antenna with screws (6) and washers (4). I 7) Connect connector (1). Seal hole (7) with some sealant (TB 09-904). I All 8) Apply a bead of sealant (TB 09-903) around the antenna. Smooth the bead. 9) Make sure all the tools and materials are removed and the work area is clean and free from debris. 10) Install door 242 and close baggage compartment door 219. 11) Perform an operational test of the system. AAAA |