|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Do not overstress the oxygen supply hose (12) and observe the safety precautions -refer to 35-00-00. All 11) If installed, disconnect intercom system connection jacks (2). Pay attention to the grounding wire riveted to front structure (3), disconnect it from the connection jack. 12) Remove tunnel (8). 2. INSTALLATION OF THE TUNNEL (Figures 401 and 401A) A. Tools and consumable materials - Adhesive (TB 08-907) - Teflon tape (TB 09-901) - White paint ADAA Validity : S / N 1 - 587, 589 - 599, 601 - 609 25-15-00Page 401 (EA) SEP 04 B. Procedure 1) Check the parts for correct condition, replace if necessary. 2) Make sure all the tools and materials are removed and the work area is clean and free from debris. 3) Position tunnel (8). With oxygen system WARNING : OBEY THE SAFETY PRECAUTIONS DESCRIBED IN 35-00-00. CAUTION : ANY ACTION ON OXYGEN SYSTEM MUST BE CARRIED OUT BY QUALIFIED PERSONNEL ONLY. 4) Apply the oxygen system procedure - refer to 35-00-00. 5) Correctly route oxygen supply hose (12) and position it into guiding clip (13) and holding tab (14) - refer to Detail A. 6) Remove blanking caps and plugs, connect oxygen supply hose (12) with teflon tape (TB 09-901) - refer to 20-00-02. 7) Perform a leakage test on oxygen system - refer to 35-00-00. 8) Mark the nut of oxygen supply hose (12) with white paint. All 9) If installed, connect intercom system connection jacks (2). Pay attention to the grounding wire riveted to front structure (3), connect it to the connection jack. 10) Secure tunnel (8) to angle bracket (7) and to the rear section with screws (9). 11) Install both side guides (6), secure with washers (5) and screws (4). 12) Install ashtray (11). 13) Stick microphone recess (1) onto tunnel (8) using adhesive (TB 08-907). 14) Stick the tunnel and rear section carpet using adhesive (TB 08-907). 15) Install the front seat belt attachments. 16) Move the front seats to normal position. 17) Perform a radio test - refer to 23-10-00. With oxygen system 18) Perform an operational test on oxygen system - refer to 35-00-00. ADAA Validity : S / N 1 - 587,589 - 599,601 - 609 25-15-00Page 402 (EA) SEP 04 1 - Microphone recess 2 - Intercom system connection jack 3 - Front structure 4 - Screw 5 - Washer 6 - Side guide 7 - Angle bracket 8 - Tunnel 9 - Screw 11 - Ashtray Tunnel - Removal / Installation Figure 401 - Without oxygen system ADAA Validity : S / N 1 - 587, 589 - 599, 601 - 609 Page 403 25-15-00 (EA) SEP 04 1 - Microphone recess 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 25 EQUIPMENT FURNISHINGS TB20飞机维护手册 设备及装饰(23) |
