|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
2) Remove ashtray (7), then remove the screw located in the ashtray housing. 3) Remove screw (11), then remove rudder tab control knob (10). 4) Remove screw (9). 5) Disengage rear covering plate (13) to remove radio connection jacks (8), disconnect lighter (6) power supply wires and pitch trim (12) lighting power supply wires. 6) Remove rear covering plate (13). 7) Move control levers (5), (14) and (15) to maximum aft position. 8) Remove screws (1) and (16), retain cup washers (2) and (17). 9) Pull front covering plate (18) rearward to remove it. 10) If necessary, remove screws (3), washers (4) and the switch-breaker support. NOTE : The sides of the front tunnel are not removable, they are riveted to the floor, the firewall and the front table. 2. INSTALLATION OF THE CENTRAL PEDESTAL CONSOLE (Figure 401) A. Tools and consumable materials None B. Procedure 1) Check the parts for correct condition, replace if necessary. 2) Make sure all the tools and materials are removed and the work area is clean and free from debris. 3) If removed, secure the switch-breaker support with washers (4) and screws (3). 4) Push front covering plate (18) forward to install it. Secure with cup washers (2) and (17) and screws (1) and (16). 5) Move control levers (5), (14) and (15) to maximum forward position. 6) Install rear covering plate (13). 7) Connect lighter (6) power supply wires and pitch trim (12) lighting power supply wires. 8) Install radio connection jacks (8) according to wire marking. NOTE : Install the "reception" connection jacks (large diameter) at the front, and the "micro" connection jacks (small diameter) at the rear. AIAB Validity : S / N 588, 600, 610 - 730 25-14-00Page 401 (EG) SEP 04 1 - Screw 2 - Cup washer 3 - Screw 4 - Washer 5 - Mixture control 6 - Lighter 7 - Ashtray 8 - Radio connection jacks 9 - Screw 10 - Rudder tab control knob 11 - Screw 12 - Pitch trim 13 - Rear covering plate 14 - Propeller control 15 - Throttle control 16 - Screw 17 - Cup washer 18 - Front covering plate Central pedestal console - Removal / Installation Key to Figure 401 AIAB Validity : S / N 588, 600, 610 - 730 25-14-00Page 402 (EG) SEP 04 Central pedestal console - Removal / Installation Figure 401 AIAB Validity : S / N 588, 600, 610 - 730 25-14-00Page 403 (EG) SEP 04 9) Secure rear covering plate (13) and rear tunnel upholstering front lug with screw (9). 10) Install rudder tab control knob (10) and secure with screw (11). 11) Install the screw in ashtray (7) housing. 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 25 EQUIPMENT FURNISHINGS TB20飞机维护手册 设备及装饰(20) |
