|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
- the autopilot alarm (if installed), - the emergency light spot (if installed), - the rear overhead light, - the rear vents. 4. OPERATION A. Front seats The various possibilities of seat adjustment depend on the chosen version. AEAA Validity : S / N 1 - 9999 Pre-MOD. 151 25-10-00 Page 2 SEP 04 - To move the seat forward and aft (*) : Use the adjustment handle located at the front of the seat, under the seatpan and grasp the handle located under the instrument panel strip. - To tilt the seat (*) : Use the lever located on the outboard side of the seat. - To change the seat backrest angle (if possible) : Use the knurled knob located at the bottom on the inboard side of the backrest. - To adjust the backrest, at lumbar level (if possible) : Use the knob located above the knurled knob on the inboard side of the backrest. Press on the knob and moderately lean back to the desired position, release the button, the backrest should fit perfectly with your back. (*) Lift adjustment handle or lever to unlock ; when in desired position, release handle or lever and check for correct locking. B. Headrest (if installed) 1) Headrest with centering bush (bearing an arrow) : - To adjust and remove the headrest : Simply slide it vertically. - To fit the headrest into the seat backrest : Turn the centering bush (bearing an arrow) 1/4 turn clockwise (in the arrow direction) and hold it to fit the headrest in the backrest. 2) Headrest without centering bush (without an arrow) : - To install, adjust or remove the headrest, simply slide it vertically. If the oxygen equipment is installed, the masks are stored inside the headrests. C. Front seat belts 1) To lock the belts : Engage the movable strap into the rigid strap until they click. Should jamming occur during this operation, slightly ease back (5 in. approximately), then unwind the strap again. 2) To unlock the belts : Depress the red unlocking push-button to free the movable strap. D. Rear seat belts 1) Belts with bands a) To lock the belts : Lift the lock in order to insert the band until sufficient tightening. Fold down the handle until it clicks on the lock. AEAA Validity : S / N 1 - 9999 Pre-MOD. 151 25-10-00 (FA) Page 3 JUN 01 b) To unlock the belts : Lift the lock to free the band. 2) Belts with adjustable straps a) To lock the belts : Engage both straps until they click. Be sure the belt is properly tightened (adjustment is possible on both straps). b) To unlock the belts : Pull on the unlocking handle to release the straps. AEAA Validity : S / N 1 - 9999 Pre-MOD. 151 25-10-00 (FA) Page 4 JUN 01 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 25 EQUIPMENT FURNISHINGS TB20飞机维护手册 设备及装饰(10) |
