曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
%
Doc. No. 6.01.05-E Revision 1 03-Mar-2003 Page 8 - 8
8.4.7 ROAD TRANSPORT
For transporting the airplane on the road it is recommended that an open trailer be used. All airplane components must be stored on a cushioned surface and secured to avoid any movement during transportation.
1. Fuselage:
The fuselage should stand on the main and nose landing gear. It must be ensured that the fuselage will not move in any direction. Furthermore, it must be ensured that the propeller has sufficient clearance so that it cannot be damaged due to fuselage movement during transportation.
2. Wings:
For transportation, both wings must be removed from the fuselage. To avoid any damage, the wings must be stored in an upright position on the leading edge with the root rib area positioned on an upholstered profiled surface with a width of at least 400 mm (1.3 ft). The outside wing area (approximately 3 m (10 ft) from the root rib area) must be placed on an upholstered profiled surface with a minimum width of 300 mm (1 ft).
The wings must be secured to avoid any sliding movement to the rear.
3. Horizontal stabilizer:
The horizontal stabilizer must be stored flat on the trailer and secured with straps, or in an upright position sitting on the leading edge on a profiled surface. All storing surfaces must be upholstered with felt or cellular rubber.
%
Doc. No. 6.01.05-E Revision 1 03-Mar-2003 Page 8 - 9
8.5 CLEANING AND CARE
CAUTION
The airplane must be kept clean. The bright surface prevents the structure from overheating.
CAUTION
Excessive dirt deteriorates the flight performance.
8.5.1 PAINTED SURFACES
The entire surface of the airplane is painted with a white weatherproof two component paint. Nevertheless, the airplane should be protected against moisture and dampness. The airplane should not be stored outdoors for long periods of time. Moisture that has penetrated must be removed by storing the affected parts in a dry place and turning them over several times.
Dirt, insects, etc. can be removed with water alone and if necessary with a mild detergent. An automotive paint cleaner can be used for stubborn spots. For best results, clean the airplane after the day's flying is ended, so that the dirt will not become ingrained.
Oil stains, exhaust stains, etc. on the lower fuselage skin can be removed with a cold detergent. Before starting, ensure that the detergent does not affect the surface finish. Use commercial automotive preservatives without silicone additives to conserve the paint finish.
%
Doc. No. 6.01.05-E Revision 1 03-Mar-2003 Page 8 - 10
8.5.2 CANOPY AND REAR DOOR
The canopy and rear door should be cleaned with 'Plexiklar' or any other acrylic glass detergent if available; otherwise use lukewarm water. Final cleaning should be done with a clean piece of chamois-leather or soft cloth. Never rub or polish dry acrylic glass.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：钻石40飞机飞行手册 DA 40 Airplane Flight Manual(75)
| 
