返回首页
当前位置: 主页 > 通航资料 > 钻石 >

钻石40飞机飞行手册 DA 40 Airplane Flight Manual(71)

时间:2011-10-28 12:56来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
The pilot may initiate additional system tests by holding the 'acknowledge' button for 2 seconds. All lights will begin to blink, and the aural alert will sound continuously.
Warning messages A warning is indicated by a continuous aural alert (sounded in the airplane's intercomm system), blinking of the red WARNING light, and blinking of the red warning light associated with the affected system.
By pressing the 'acknowledge' button, which is now illuminated green, the aural alert will be terminated, and the WARNING light will be extinguished. The warning light associated with the affected system will change from blinking to solid illumination.
Doc. No. 6.01.05-E  Revision 3  26-May-2003  Page 7 - 47 


Door warning (DOORS)
The door warning is indicated when one of the two cabin doors is not closed or latched.
Starter warning message (START)
The starter warning message is displayed when the connection between the starter motor and the engine has not been broken. This occurs when the pinion of the starter motor remains engaged.
Furthermore, the START warning light is illuminated continuously as long as the starter is being operated. In this case the WARNING light and the aural alert will not be activated.
The procedure to be followed upon starter warning is given in 3.7.2 FAILURES IN THE ELECTRICAL SYSTEM.
Trim failure warning message (TRIM FAIL)
The White Wire annunciator panel is prepared for the installation of an autopilot in the DA 40 D. When the autopilot is installed and ready for operation, this warning message indicates a failure of the automatic trim system of the autopilot. For further details, refer to the Supplement to the AFM for the autopilot (if installed).
Caution messages A caution is indicated by a momentary aural alert (sounded in the airplane's intercomm system), blinking of the amber CAUTION light, and blinking of the amber caution light associated with the affected system.
By pressing the 'acknowledge' button, which is now illuminated green, the CAUTION light will be extinguished. The caution light associated with the affected system will change from blinking to solid illumination.
Doc. No. 6.01.05-E  Revision 3  26-May-2003  Page 7 - 48 


Alternator caution message (ALTERNATOR)
The alternator caution message is displayed on alternator failure. The only remaining source of electrical power is the battery.
The procedure to be followed upon alternator caution is given in 4B.3.4 ALTERNATOR FAILURE.
Low voltage caution message (LOW VOLTS)
The low voltage caution message is displayed when the on-board voltage drops below
12.6 volts. It is terminated when the voltage exceeds 12.9 volts again.
The procedure to be followedupon low voltage caution is given in 4B.3.1 LOW VOLTAGE CAUTION (LOW VOLTS).
Engine control unit caution message (ECU A or ECU B)
This caution message is displayed in case of a malfunction of the related engine control unit (ECU A or ECU B).
 
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址:钻石40飞机飞行手册 DA 40 Airplane Flight Manual(71)
 

------分隔线----------------------------