曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
2) Remove screws (5) and washers (4). 3) Remove tail cone (3). 2. INSTALLATION OF THE TAIL CONE (Figure 401) A. Tools and consumable materials None B. Procedure Pre-MOD. 151 - refer to Detail B 1) Prior to tail cone installation, inspect : - for cracks or crazing, - the attaching holes for elongation, With rear light - the rear light wire for routing and condition, - the attachment of rear light wire for condition, the bulb and the glass of rear light (2) for condition and attachment, - connectors (1) for condition. 2) If the rear light is installed, connect connectors (1). 3) Make sure all the tools and materials are removed and the work area is clean and free from debris. 4) Install tail cone (3) on frame C9 (6), then install washers (4) and screws (5). 5) Check elevator (7) for freedom of travel. WA Validity : S / N 1 - 9999 53-20-04Page 401 (BA) SEP 04 6) If the rear light is installed, close navigation light and anticollision light switch-breakers and check rear light (2) for correct operation. Post-MOD. 151 - refer to Detail A 1) Prior to tail cone installation, inspect : - for cracks or crazing, - the attaching holes for elongation. 2) Make sure all the tools and materials are removed and the work area is clean and free from debris. 3) Install tail cone (3) on frame C9 (6), then install washers (4) and screws (5). 4) Check elevator (7) for freedom of travel. AAAA Validity : S / N 1 - 9999 Page 402 53-20-04 (BA) SEP 04 1 - Connector
|