曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
(+ 20 ; - 0)
Ground EP1N 11
Ground EP2N 12
Gages - Inspection / Check
Figure 602
AEAB
Validity : S / N 275 - 968, 970 - 1184, 1186 - 1213,
1215 - 1477, 1479 - 1505, 1509 - 1512 28-40-01Page 605
(EA) SEP 02
1 - Electric connector
2 - Engine monitoring cluster
EJ5E
11 12 7 6 14 10 3 8 1
JAEGER Transmitter
MAGNET! MARELLI Transmitter
Gages - Inspection / Check
Figure 603
AEAB
Validity : S / N 275 - 968, 970 - 1184, 1186 - 1213,
1215 - 1477, 1479 - 1505, 1509 - 1512 28 40 01 (EA)
PageSEP2 6006
GAGING CONDITIONER
REMOVAL / INSTALLATION
1. REMOVAL OF THE GAGING CONDITIONER (Figure 401)
A. Tools and consumable materials
None
B. Procedure
1) Open main switch-breaker.
2) Install the warning sign prohibiting main switch-breaker operation.
WARNING
DO NOT OPERATE
MAINTENANCE WORK IN PROGRESS
3) Remove the cowling under hull 218A.
4) Disconnect connectors (1), (2) and (9) from gaging conditioner (6).
5) Hold gaging conditioner (6), remove bolts (8) and washers (7) and then, remove gaging conditioner (6).
6) If it is necessary to replace a gaging conditioner at amendment A with a gaging conditioner at the same amendment, perform the following operations :
a) Remove extension screws (3) and washers (4) and disconnect filtering adapters (5) from gaging conditioner (6).
b) Connect filtering adapters (5) to new gaging conditioner (6) and install washers (4) and extension screws (3).
NOTE : Filtering adapters are integral with the gaging conditioners from amendment B.
2. INSTALLATION OF THE GAGING CONDITIONER (Figure 401)
A. Tools and consumable materials
None
B. Procedure
1) Clean and repair if necessary the surfaces to be bonded electrically - refer to 20-00-12.
2) Install gaging conditioner (6) and grounding wires (10), secure them with bolts (8) and washers (7).
3) Apply varnish to electrical bondings - refer to 20-00-12.
4) Connect P058 connector (9) to J1 connector of gaging conditioner (6).
5) Connect P059 connector (2) to J3 connector of gaging conditioner (6).
6) Connect P060 connector (1) to J2 connector of gaging conditioner (6).
I ABAA
Validity : S/N 969, 1185, 1214, 1478, 1506 - 1508, 1513 - 9999 28-40-02Page 401
(CA) SEP 04
7) Remove the warning sign prohibiting main switch-breaker operation.
8) Close main switch-breaker.
9) Make sure the quantity of fuel in the tanks is the same as the quantity displayed on the indicators. Adjust it if necessary - refer to 28-40-01.
10) Make sure all the tools and materials are removed and the work area is clean and free from debris.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 28 FUEL TB20飞机维护手册 燃油(50)
|
