曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
INDICATOR ?
IS EJ10 WIRING CORRECT ?
YES
REPLACE ENGINE
MONITORING CLUSTER
REPLACE OR REPAIR
EJ10 WIRING
V
END OF TESTS
•
REPLACE R.H. WING
SENSORS
I AAAA
Validity S / N 969,1185, 1214, 1478, 1506 - 1508, 1513 - 9999
28-40-00 Page 106
(BA) SEP 04
GAGES
REMOVAL / INSTALLATION
WARNING : OBEY THE SAFETY PRECAUTIONS DESCRIBED IN 28-00-00.
NOTE : This procedure is applicable to L.H. and R.H. installations. Information specific to R.H. installation are given in square brackets.
NOTE : Removal and installation of gages do not affect adjustment. However, if an adjustment is necessary, it should be done only by a specialized workshop or by the manufacturer. Thus, before dispatching gages, make sure that an adjustment or a replacement is necessary.
1. REMOVAL OF THE GAGES (Figure 401)
A. Tools and consumable materials None
B. Procedure
WARNING : APPLY THE MAINTENANCE PROCEDURE OF THE FUEL TANKS — REFER TO 28-00-00.
1) Drain the fuel tanks - refer to 12-11-02.
2) Remove the inspection doors 512 and 516 [612 and 616] and 515 [615], if necessary - refer to 52-40-00.
3) Remove nuts (14) and (17), washers (13) and (21), bolts (11) and (22) and discard cotter pins (15) and (18). Disconnect intermediate aileron control rod (10) from bellcranks (12) and (20).
4) Pull rod (10) towards the wing tip.
5) Disconnect electric connector (8) from gage (5).
6) Remove bolts (4) securing gage (5) to base (7). Retain washers (3).
7) Disengage gage (5) from wing.
8) Discard seal (6).
2. INSTALLATION OF THE GAGES (Figure 401)
A. Tools and consumable materials
None
B. Procedure
WARNING : APPLY THE MAINTENANCE PROCEDURE OF THE FUEL TANKS — REFER TO 28-00-00.
CAUTION : MAKE SURE GAGES ARE CORRECTLY POSITIONED IN THE WINGS. NOTE 1 : Cylindrical float gages - Detail B
Root gage rod elbowed at 64°
Tip gage rod elbowed at 72° 30'
ADAB
Validity : S / N 275 - 968, 970 - 1184, 1186 - 1213,
1215 - 1477, 1479 - 1505, 1509 - 1512 28-40-01Page 401
(DA) SEP 02
NOTE 2 : Oblong float gages - Detail C
Root gage rod elbowed at 56°
Tip gage : rod elbowed at 66° 30'
The oblong float gages have a distinctive mark on the body (color point) in order to avoid
installation errors during their replacement.
L.H. wing : Root gage green point
Tip gage black point
R.H. wing : Root gage red point
Tip gage black point
1) Install a new seal (6) on gage (5).
CAUTION : MAKE SURE GAGE (5) IS CORRECTLY POSITIONED ON BASE (7).
2) Install gage (5) on base (7) and attach it with bolts (4) and washers (3).
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 28 FUEL TB20飞机维护手册 燃油(41)
|
