曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
14) Perform a leakage test with the fuel system pressurized - refer to 28-00-00.
15) Check for leaks.
16) Mark with a red paint line the nuts of tubes (1), (5) and (6) and three-way cock (2).
17) Make sure all the tools and materials are removed and the work area is clean and free from debris.
18) Tilt the instrument panel forward and lock it - refer to 31-10-01.
19) Install the inspection door 212L.
20) Install engine cowling 121 - refer to 71-10-01.
WA
Validity : S / N 1 - 730 28-20-04Page 402
(BA) SEP 02
1 - Tube
2 - Three-way cock
3 - Washer
4 - Nut
5 - Fuel tube
6 - Tube
7 - Bolt
8 - Control tube
9 - Control knob
10 - Washer
11 - Nut
12 - Control shaft
PAGE INTENTIONALLY LEFT BLANK
WA
Validity : S / N 1 - 730 28-20-04Page 404
(BA) SEP 02
FUEL SELECTOR CONTROL
REMOVAL / INSTALLATION
1. REMOVAL OF THE FUEL SELECTOR CONTROL (Figure 401)
A. Tools and consumable materials
- Cable grip P/N T700A2799000008
B. Procedure
1) Remove the R.H. front seat - refer to 25-11- 00.
2) Detach carpet at the R.H. pedestal side lower section by about 8 in (200 mm) - refer to Detail A.
3) Remove and discard nut (60), remove washer (59) and bolt (58).
4) Remove the rear cover from central control pedestal - refer to 25-14-00.
5) Block the elevator tab cable (53) at the lower part of handwheel (51) with a cable grip (52) to avoid an untimely unwinding of the cable on handwheel.
6) Remove the two bolts (29) and washers (28).
7) Remove bolt (4) and retain washer (5).
8) Disconnect, if necessary, microswitch (3) and disengage knob support (30).
9) Disengage cam assembly (6).
10) Remove bolts (13) and washers (14).
11) Disassemble front pulley (54), retain the shaft, the washer, the nut and discard cotter pin (55).
12) Disengage cable (53) (two strands) to remove support (12). To do so, route it it between supports (21) and (12), use a screwdriver as a lever at point "a" if necessary.
13) Remove support (12).
14) If necessary, perform the following operations :
a) To disengage tube (19), remove and discard nut (18), remove bolt (20) and washer (17).
b) To disengage shaft (7), remove circlip (16) and retain washer (15).
c) To remove large gear (24) from shaft (22), remove and discard nut (26), remove screw (27) and washer (25).
d) To remove small gear (11) from shaft (7), remove and discard nut (10), remove bolt (8) and washer (9).
2. INSTALLATION OF THE FUEL SELECTOR CONTROL (Figure 401) A. Tools and consumable materials
- Grease (TB 04-004A)
- Sealant (TB 08-907)
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 28 FUEL TB20飞机维护手册 燃油(32)
|
