|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
NOTE : Splices must be removed due to the narrowness of the passage inside the tube. 7) Note the length of the wires equipped with splices and discard them. 8) Cut and discard the male contacts of the wires not equipped with splices. 9) Disconnect R003 connector, then mark and disconnect the wires. 10) Cut off and discard the male contacts. 11) Disconnect the wire from ground terminal block GS 23 and cut it down to the clip ; discard the clip and the sleeve. 12) Remove and discard nut (13) ; remove washers (12) and (4) and bolt (3). 13) Remove and discard nut (7) ; remove washer (8) and bolt (10) from "Nose up" stop (9). 14) Attach a length of lockwire, 79 in (2 m), to wiring end. CAUTION : AUTOPILOT WIRING ONLY MUST BE REMOVED FROM THE CONTROL WHEEL SLIDING TUBE. MAKE SURE THE SECOND WIRING REMAINS IN POSITION. 15) Disengage control wheel (1) from tube (6) and carefully pull backward while easing the passage of NP wiring through tube (6). NOTE : If necessary, coat wiring sheath with petrolatum (TB 04-003) to ease the passage. AAAA Validity : S / N 1 - 9999 27 30 01 (BA) MAR 00 Page 202 16) When tube (6) opening is sufficiently cleared, use a steel curved rod (or any other means) to remove the two springs retaining wiring assemblies inside the tube. 17) Progressively remove wiring from tube (6) while assisting its passage through the grommet. 18) Remove control wheel (1) equipped with NP wiring, cut lockwire and leave it in place for reinstallation. F. Installation of control wheel with autopilot (Figure 201) 1) Check the condition of the wiring and control wheel (1), then attach lockwire to the wiring and route wiring inside tube (6) by pulling it from the front. NOTE : If necessary, coat wiring sheath with petrolatum (TB 04-003) to ease the passage. 2) Before positioning control wheel (1), correctly engage and position the two springs on either side of the control wheel tube locking hole. 3) If installed, insert the wires of the switch, the map reading light and the chronometer into control wheel (1). 4) Position and secure "Nose up" stop (9) with bolt (10), washer (8) and new nut (7). Exercise care not to pinch the wiring. 5) Engage and secure control wheel (1) onto tube (6) with bolt (3), washers (4) and (12) and new nut (13). 6) Cut and discard lockwire and make sure the grommet is correctly installed on the control wheel tube. 7) Recondition the wiring - refer to Section 6 of the Electrical Maintenance Manual or to Chapter 20-50-00 of the Wiring Manual. 8) Correctly route the wiring and install tie-wraps. 9) Connect R20 and R003 connectors and connect the wire to ground terminal block GS 23. 10) If installed, solder the wires of the map reading light switch and connect the light. 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 27 FLIGHT CONTROLS TB20飞机维护手册 飞行操纵(35) |
