曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
CAUTION : EXERCISE SPECIAL CARE WHEN POSITIONING THE TOOL IN ORDER NOT TO DAMAGE THE INSTALLED ANTENNAS AND THE SKINS. 5) Position rudder travel jig (5) TB10 00000. NOTE : Position and secure neutral setting support (6) according to the TB20 reference mark, with centering plate (7) in max. rear position. 6) Push centering plate (7) of travel jig (5) forward to check rudder (8) position. 7) Remove centering plate (7). 8) Fully depress and hold L.H. rudder pedal. 9) Check that stop bolt (12) of interconnection lever (2) fully abuts against nose gear mount (3). 10) Make sure rudder (8) does not contact mechanical stop (13). 11) On travel jig (5), check that travel angle equals 25° ± 2°. 12) If necessary, adjust stop bolt (12) on interconnection lever (2), then repeat steps 10) and 11). 13) Fully depress and hold R.H. rudder pedal. 14) Check that stop bolt (11) of interconnection lever (2) abuts against nose gear mount (3). 15) Make sure rudder (8) does not contact mechanical stop (13). 16) On travel jig (5), check that travel angle equals 25° ± 2°. 17) If necessary, adjust stop bolt (11) on interconnection lever (2), then repeat steps 15) and 16). CAUTION : EXERCISE SPECIAL CARE WHEN REMOVING THE TOOL IN ORDER NOT TO DAMAGE THE INSTALLED ANTENNAS AND THE SKINS. 18) Remove travel jig (5). 19) Make sure all the tools and materials are removed and the work area is clean and free from debris. 20) Lower the aircraft onto the ground and remove the jack. Post-MOD. 151 21) Install dorsal fin 225. All 22) Install engine cowlings 121 and 131 - refer to 71-10-01. ABAA Validity : S / N 1 - 9999 27-20-00Page 202 (CA) SEP 04 1 - Nose wheel Ligne de rivets Rivets line
|