曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
5
6
Rudder rods and levers
Table 202 (1/2)
ABAA
Validity : S / N 1 - 9999 27-20-00Page 213
(CA) SEP 04
ITEM THEORETICAL
DIMENSION MAXIMUM WEAR
DIMENSION BORING DECISION ACTION
7 Dia. 0.4724/0.4735 in
(12.0/12.027 mm) Dia. 0.4751 in
(12.070 mm)
8
9
10 Dia. 0.2362/0.2381 in
(6.0/6.048 mm) Dia. * 0.2409 in
(6.120 mm)
11
12
13
14
15
16
(*) Maximum wear dimension without pitting marks.
Wear mark on rod body due to contact : maximum depth 0.019 in (0.5 mm).
Rudder rods and levers
Table 202 (2/2)
ABAA
Validity : S / N 1 - 9999 27-20-00Page 214
(CA) SEP 04
RUDDER PEDALS
MAINTENANCE PRACTICES
1. SERVICING None
2. REMOVAL / INSTALLATION - RUDDER PEDALS
A. Tools and consumable materials
- Grease (TB 04-004A)
- Adhesive tape (TB 08-919A)
B. Removal of rudder pedals (Figure 201)
1) Disconnect the battery - refer to 24-30-02.
2) Install the warning sign prohibiting main switch-breaker operation.
WARNING
DO NOT OPERATE
MAINTENANCE WORK IN PROGRESS
3) Remove the front seats - refer to 25-11-00.
4) Remove inspection doors 211 L and 211 R (if installed) and 235L and 235R.
5) If installed, remove the transponder and / or the ADF receiver - refer to 34-50-00.
6) Remove the visors and tilt R.H. and L.H. instrument panels.
7) Disconnect the leads from ground terminal block GS 23 (R.H. side).
8) Remove and discard cotter pins (21) ; remove washers (20) and disconnect brake rods (22).
9) If installed, remove the master cylinders from their support on R.H. station (without disconnecting the
hoses).
10) Remove and discard cotter pins (18) ; remove nuts (17) and shouldered washers (16). NOTE : Mark the mounting direction of shouldered washer (16).
11) Disconnect interconnection rods (19) from the rudder pedals.
12) Remove and discard nuts (6) ; remove washers (5) and bolts (4) from lever (7).
13) Remove and discard nut (15) ; remove washer (14) and bolt (13).
14) Counter-drill the head of blind rivet (8), retain washer (9) and clamp (10).
15) Remove the Alternate Air control - refer to 76-10-02.
16) While holding the rudder pedals, remove and discard nuts (2), remove washers (3) (or retaining plate)
and lower half-bearings (1).
17) Disengage R.H. and L.H. rudder pedals from the pedestal.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 27 FLIGHT CONTROLS TB20飞机维护手册 飞行操纵(21)
| 
