返回首页
当前位置: 主页 > 通航资料 > TB >

TB20 MAINTENANCE MANUAL 73 发动机燃油和控制 TB20飞机维护手册(17)

时间:2011-11-12 05:05来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
8) Make sure the maximum quantity of usable fuel is displayed - refer to Table below.

Type of aircraft Maximum quantity of usable fuel
 US Gal Liters Pounds Kilos
TB 20 /TB 21 86.1 326 577 262
TB 200 53.9 204 361 164

9) Make sure software version is displayed.
10) End of the test and return to continuous display of fuel flow.
11) Open main switch-breaker.
12) If connected, disconnect the ground power unit - refer to 24-40-00.
WA
Validity : With SHADIN 912080-38 fuel flowmeter 73-30-03Page 503
(BA) SEP 02
 
 
 

 
Fuel flow indicator - Adjustment / Test
Figure 501
WA
Validity : With SHADIN 912080-38 fuel flowmeter 73-30-03 (BA)Page 504
SEP 02
 
FUEL FLOW INDICATOR
ADJUSTMENT / TEST
1. ADJUSTMENT OF FUEL FLOW INDICATOR (Figure 501)
NOTE : Apply this adjustment procedure imperatively when you replace flow transmitter or fuel flow indicator.
A. Tools and consumable materials
- Ground power unit
B. Procedure
1) Record "K" factor (3) displayed on flow transmitter (2).
2) Make sure that the main switch-breaker is open.
3) Remove fuel flow indicator (1) without disconnecting it.
4) Remove and discard "CAUTION" red adhesive label (4).
5) Make sure the graduated thumbwheels are set to the following positions :
- SW1 set to "F",
- SW2 set to "F",
- SW3 set to "0",
- SW4 set to "0".
CAUTION : DO NOT CHANGE THE POSITION OF SW1, SW3 AND SW4 GRADUATED THUMBWHEELS FOR PROGRAMMING.
6) Set SW2 graduated thumbwheel to "E". The fuel flow indicator is in calibrate mode, group 1 and group 2 data can be programmed.
7) Connect the ground power unit - refer to 24-40-00.
8) Close main switch-breaker.
9) Perform a check sequence of fuel flow indicator (1) - refer to Tables below. Depress "USED" switch to change the indication.
- Group 1

INDICATION VALUE REMARKS
 L0(
)00 Display the value of "K" factor recorded on flow transmitter using "ADD" switch
R 0 Unused
A 0 Unused
B 0 Unused
U 0 Unit of measure (0 = US Gallons)
E 0 Number of engines (0 = single engine)
C 0 Cutoff of fuel flowmeter for residual voltage

ABAB
Validity : With SHADIN 912041T-38D fuel flowmeter 73-30 03Page 501
(CA) SEP 02
 
- Group 2

INDICATION VALUE REMARKS
0 1 or 5 Type of RS232 output : 1 for King GPS
5 for Garmin GPS
I 1 Active input (RS232)
 
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址:TB20 MAINTENANCE MANUAL 73 发动机燃油和控制 TB20飞机维护手册(17)
 

------分隔线----------------------------