|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
12) Install lockwire on hoses (16). AIAI Validity : De-iced three-blade propeller 61 10-00 (FM) Page 402 SEP 04 13) Remove the blanks. Install and lockwire ring sprayer (13), then check t he clearance - refer to 30-60-00. 14) Check adhesive tapes (28) for condition on cylinder side bulkhead 1). 15) Position and attach spinner (27) with screws (3) and washers (2). NOTE : If spinner (27), inside, and engine side bulkhead (8), on its front part, are marked with a red paint line, align these lines during installation. NOTE : If slack appears at cylinder side bulkhead (1), add adhesive tape (28) - refer to Illustrated Parts Catalog. 16) Install the engine cowlings - refer to 71-10-01. 17) Perform a test run-up - refer to 05-30-02. 18) After the run-up, check for traces of leaks (oil) around propeller atta chment. 19) Perform a test flight - refer to 05-30-00. 1 - Cylinder side bulkhead 2 - Washer 3 - Screw 4 - Propeller 5 - Bolt 6 - Bolt 7 - Washer 8 - Engine side bulkhead 9 - Spacer 10 - Washer 11 - Nut 12 - Brush ring 13 - Ring sprayer 14 - 0-ring 15 - Slinger ring 16 - Hose 17 - Nut 18 - Washer 19 - Spacer 20 - Nut 21 - Bolt 22 - Washer 23 - Nut 24 - Propeller sprayer 25 - Bolt 26 - Groover rubber strip 27 - Spinner 28 - Adhesive tape De-iced propeller - Removal / Installation Key to Figure 401 |
