|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
6) Remove the blanking caps and install a new 0-ring (10). 7) Position engine side bulkhead (8) onto the propeller and take propeller sprayers (7) position into account. ADAD Validity : S / N 1184 - 1472, Pre-Kit OPT10 918600 61 10 00Page 401 (DA) SEP 04 8) Position propeller (4) and align the "0" of the propeller with the "0" of brush ring (9) . 9) Screw bolts (6) equipped with nuts (5). 10) Torque bolts (6) according to "Specific cases" tightening procedure - refer to 20-00-01. 11) Lockwire. 12) Mark nut position with a red paint line. 13) Install propeller sprayers (7). Lockwire tube nuts. 14) Attach propeller sprayers (7) on bracket (16) with clamps (13), bolts (14) and new nuts (15). 15) Check adhesive tapes (20) for condition on cylinder side bulkhead (1). 16) Position and attach spinner (19) and equipped covers (18) with screws (3) and washers (2). NOTE : If spinner (19), inside, and engine side bulkhead (8), on its front part, are marked with a red paint line, align these lines during installation. NOTE : If slack appears at cylinder side bulkhead (1), add adhesive tape (20) - refer to Illustrated Parts Catalog. 17) Install the engine cowlings - refer to 71-10-01. 18) Perform a test run-up - refer to 05-30-02. 19) After the run-up, check for traces of leaks (oil) around propeller attachment. 20) Perform a test flight - refer to 05-30-00. 1 - Cylinder side bulkhead 12 - Nut 2 - Washer 13 - Clamp 3 - Screw 14 - Bolt 4 - Propeller 15 - Nut 5 - Nut 16 - Bracket 6 - Bolt 17 - Bolt 7 - Propeller sprayer 18 - Equipped cover 8 - Engine side bulkhead 19 - Spinner 9 - Brush ring 20 - Adhesive tape 10 - 0-ring 11 - Washer
|
