返回首页
当前位置: 主页 > 通航资料 > 钻石 >

钻石20飞机飞行手册 DA 20 Airplane Flight Manual(69)

时间:2011-10-28 13:14来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  


6.
WEIGHT AND BALANCE ........................................................................................... S3-2


7.
DESCRIPTION OF THE AIRPLANE AND ITS SYSTEMS ......................................... S3-3


8.
HANDLING, PREVENTIVE AND CORRECTIVE MAINTENANCE............................. S3-4

 


1. GENERAL
The installation is defined by Service Bulletin DAC1-33-01.
2. OPERATING LIMITATIONS
2.15. PLACARDS
1. On the instrument panel above the individual circuit breakers 

Figure 1.
3. EMERGENCY PROCEDURES
There are no changes to the airplane emergency procedures when the Recognition Lights are installed.
4. NORMAL PROCEDURES
Pulsing the landing/taxi lights enhances the aircraft flight path recognition quality and may be used any time the pilot desires. It is recommended that the landing lights be turned on steady rate when the aircraft is within 200' AGL at night. 
NOTE

Pulsing should not be used when operating near clouds or on the ground.
5. PERFORMANCE
There is no change in airplane performance with the Recognition Lights installed.
6. WEIGHT AND BALANCE
The Recognition Lights installation adds 2.5 lbs (1.13 kg) of weight at a 0 in (0 m) moment arm.

7. DESCRIPTION OF THE AIRPLANE AND ITS SYSTEMS
The Recognition Light System consists of 3, 35 watt lamps located in the left wing and the landing light.  The lamps are aimed specifically to increase the aircraft's visibility on final approach and head on. One of the lamps is aimed to perform the function of the original taxi light. The 3 lamps and the original landing light are connected to a Pulselite power supply which allows one or more of the lights to be pulsed at approximately 46 times per minute.  The instrument panel modifications include a Pulse Switch on the left side of the Lights switch panel and a Pulse System circuit breaker on the right side of the Lights panel (see Figure 2).

Figure 2.
With the Taxi and Landing switches in the OFF position, selecting the Pulse switch to ON causes the three lamps and the landing light to pulse simultaneously. Selecting either the Taxi light or the Landing light to ON while the Pulse switch is in the ON position causes the corresponding lamp(s) to remain on steady.  With the Pulse switch in the off position the Taxi light and Landing light function as normal light circuits.

8. HANDLING, PREVENTATIVE AND CORRECTIVE MAINTENANCE
Service or replacement of bulbs shall be performed according to chapter 33-00 of your Diamond Aircraft Maintenance Manual (Document number DA201-C1).

CHAPTER 9

SUPPLEMENT 4
GROSS WEIGHT INCREASE (800 kg)

1.
GENERAL ................................................................................................................... S4-2


2.
OPERATING LIMITATIONS ....................................................................................... S4-2
 
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址:钻石20飞机飞行手册 DA 20 Airplane Flight Manual(69)
 

------分隔线----------------------------