曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
11. Throttle 800 to 1000 RPM
CAUTION
DO NOT OPERATE ENGINE ABOVE 1000 RPM UNTIL AN OIL TEMPERATURE INDICATION IS REGISTERED.
12.
Fuel Prime OFF
13.
Engine Instruments check
NOTE
Excessive priming can result in a flooded engine. To clear a flooded engine, turn off fuel pump and fuel prime, open throttle 1/2
-1 inch and engage starter. The engine should start for a short period and then stop. Excess fuel has now been cleared and engine start from item 1 can be performed.
CAUTION
IF OIL PRESSURE IS BELOW 10 PSI, SHUT DOWN ENGINE IMMEDIATELY (MAXIMUM 30 SECONDS DELAY).
NOTE
Oil Pressure may advance above the green arc until Oil Temp. reaches normal operating temperatures.
Regulate warm up RPM to maintain pressure below 100 psi limit. At ambient temperatures below 32o F (0o C) DO NOT apply full power if oil pressure is above 70 psi.
14. Starter Warning Light check OFF
B. Starting Engine Warm
1.
Throttle IDLE
2.
Mixture FULL RICH
3.
Toe Brakes hold
4.
Propeller Area clear
WARNING
ENSURE THAT PROPELLER AREA IS CLEAR!
CAUTION
DO NOT ENGAGE STARTER IF THE PROPELLER IS MOVING. SERIOUS DAMAGE CAN RESULT.
NOTE
Steps 5, 6, 7, 8 and 9 are to be performed without delay between steps.
5.
Fuel Pump ON
6.
Fuel Prime ON
7.
Throttle Full for prime, 1 to 3 seconds before starting
8.
Throttle 1/2 - 1 inch OPEN (approximately)
9.
Ignition Switch START, hold until engine starts or for 10 seconds maximum (repeat from Step 7 if engine does not start)
10.
Starter Warning Light illuminated while ignition is in START position
NOTE
Activate starter for maximum of 30 seconds only, followed by a cooling period of 3-5 minutes.
11.
Throttle 800 to 1000 RPM
12.
Fuel Prime OFF
13.
Engine Instruments check
NOTE
Excessive priming can result in a flooded engine. To clear a flooded engine, turn off fuel pump and fuel prime, open throttle 1/2
-1 inch and engage starter. The engine should start for a short period and then stop. Excess fuel has now been cleared and engine start from item 1 can be performed.
CAUTION
IF OIL PRESSURE IS BELOW 10 PSI, SHUT DOWN ENGINE IMMEDIATELY (MAXIMUM 30 SECONDS DELAY).
NOTE
Oil Pressure may advance above the green arc until Oil Temp. reaches normal operating temperatures.
Regulate warm up RPM to maintain pressure below 100 psi limit. At ambient temperatures below 32o F (0o C) DO NOT apply full power if oil pressure is above 70 psi.
C. After Engine has Started
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址:钻石20飞机飞行手册 DA 20 Airplane Flight Manual(66)
|