曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
3) Connect electrical connectors (10) (red sleeve to L.H. connector, green sleeve to R.H. connector). 4) If removed, install and secure locking assembly (7) with nuts (6). 5) Tilt instrument panel (1) - refer to 31-10-01, and check for correct locking. 6) Make sure all the tools and materials are removed and the work area is clean and free from debris. 7) Install and secure upholstery panel (11) with screws (8) and (14) and washers (9) and (15). 8) If removed, install and secure instrument panel cover (5) with clips (2) and install the lighting rheostat knobs. ABAC Validity : S / N 588 - 822, 850 - 887, 889 - 947 31 50 0 Page 401 1 (DA) SEP 02 9) Close main switch-breaker. 1 0) Perform a test of the advisory panel with the "TEST" pushbutton. 11 ) Open main switch-breaker. 1 - Instrument panel 2 - Clip 3 - Bolt 4 - Warning light 5 - Instrument panel cover 6 - Nut 7 - Locking assembly 8 - Screw 9 - Washer 10 - Electrical connector 11 - Upholstery panel 12 - Bolt 13 - Support 14 - Screw 15 - Washer PAGE INTENTIONALLY LEFT BLANK ABAC Validity : S / N 588 - 822, 850 - 887, 889 - 947 31 50 01Page 404 (DA) SEP 02 ADVISORY PANEL REMOVAL / INSTALLATION 1. REMOVAL OF ADVISORY PANEL (Figure 401) A. Tools and consumable materials - Wrench ARNOULD 01-907 or ARNOULD 41-939 B. Procedure 1) Make sure that the main switch-breaker is open. 2) If installed, remove instrument panel cover (5) : a) Remove the lighting rheostat knobs. b) Remove clips (2). c) Remove instrument panel cover (5). 3) Remove screws (7) and (12) and washers (6) and (11). Clear upholstery panel (9). 4) Unlock and tilt instrument panel (1) - refer to 31-10-01. 5) Disconnect electrical connectors (8). 6) Hold support (10) and remove the 3 bolts (3). Retain the nut and the washer of the L.H. attachment bolt. 7) Clear and remove support (10). 8) If necessary, disassemble warning lights (4) with the wrench ARNOULD 01-907 in the case of Detail A, or the wrench ARNOULD 41-939 in the case of Detail B. 2. INSTALLATION OF ADVISORY PANEL (Figure 401) A. Tools and consumable materials None B. Procedure 1) If removed, install warning lights (4) (with their cheeks in vertical position). 2) Connect electrical connectors (8) (red sleeve to L.H. connector, green sleeve to R.H. connector). 3) Install and secure support (10) with the 3 bolts (3), the washer and the nut of the L.H. attachment bolt. 4) Tilt instrument panel (1) - refer to 31-10-01, and check for correct locking. 5) Make sure all the tools and materials are removed and the work area is clean and free from debris. 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址:TB20 MAINTENANCE MANUAL 31 指示/记录系统 TB20飞机维护手册(20) |