|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者 23) Position the aircraft on a compensating area. 24) Perform a test run-up - refer to 05-30-02. 25) Check the parameters of the engine monitoring cluster. 26) Check the compass and, if necessary, perform a compensation - refer to 34-20-01. ABAB Validity : Post-MOD. 151 31-10 02 (DA) Page sEp40043 Raised central console Figure 401 ENGINE MONITORING CLUSTER REMOVAL / INSTALLATION 1. REMOVAL OF THE ENGINE MONITORING CLUSTER (Figures 401, 401A and 401B) A. Tools and consumable materials None B. Procedure 1) Make sure that the main switch-breaker is open. 2) Remove central console upholstering - refer to 31-10-02. 3) Remove screws (2). 4) Disengage engine monitoring cluster (1) from central console. 5) Disconnect electrical connector (3). 6) Remove engine monitoring cluster (1). Post-MOD. 186 7) If engine monitoring cluster (1) has to be replaced : a) Remove extension screws (4) and washers (5) and then, disconnect filtering adapter (6) from engine monitoring cluster. b) Connect filtering adapter (6) to the new engine monitoring cluster and install washers (5) and extension screws (4). 2. INSTALLATION OF THE ENGINE MONITORING CLUSTER (Figures 401, 401A and 401 B) A. Tools and consumable materials None B. Procedure Post-MOD. 186 1) Make sure engine monitoring cluster (1) is fitted with filtering adapter (6). All 2) Position engine monitoring cluster (1) and connect electrical connector (3). 3) Close main switch-breaker. Pre-MOD. 182 4) Check engine monitoring cluster (1) for correct operation. Adjust if necessary - refer to Page 501. Post-MOD. 182 4) Check engine monitoring cluster (1) for correct operation. All 5) Open main switch-breaker. AAAA Validity : S / N 1 - 9999 31 10-03Page 401 (BA) SEP 04 6) Make sure all the tools and materials are removed and the work area is clean and free from debris. 7) Secure engine monitoring cluster (1) with screws (2). 8) Install central console upholstering - refer to 31-10-02. 9) Perform a test run-up - refer to 05-30-02. AAAA Validity : S / N 1 - 9999 31-10-03 Page 402 (BA) SEP 04 1 - Engine monitoring cluster 2 - Screw 3 - Electrical connector Engine monitoring cluster - Removal / Installation |
