曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
L / G up - Flaps in landing position and stall (*) X X
NOTE : In (*) configuration, low-pitched and high-pitched sounds are alternating (= 1 Hz).
Central warning systems - Identification and location of components
Figure 1 - Standard Pre-MOD. 151
ADAC
Validity : S / N 1 - 9999 31 50-00Page 3
(EA) SEP 02
Central warning systems - Identification and location of components
Figure 1A - Option Pre-MOD. 151
ADAC
Validity : S / N 1 - 9999 31-50 00e4
(EA) SPEaPg 02
A - Advisory panel
B - Aural warning
Inverseur jour / nuit
Day / night toggle switch
Opt
Test des voyants indicator light test
Opt Alarme A/P ( si installee )
A/P alarm ( if installed )
Haut-parleur alarmes Alarm loudspeaker
Alarme selecteur d'altitude ( si installee ) Altitude selector alarm ( if installed )
Central warning systems - Identification and location of components
Figure 1B - Option Pre-MOD. 151
Central warning systems - Identification and location of components
Figure 1C - Standard Post-MOD. 151
A - Alarm box
Central warning systems - Identification and location of components
Figure 2
PAGE INTENTIONALLY LEFT BLANK
ADAC
Validity : S / N 1 - 9999 31-50 00Page 8
(EA) SEP 02
ADVISORY PANEL
SERVICING
1. REPLACEMENT OF AN INDICATOR LIGHT PLACARD OR BULB ON THE ADVISORY PANEL
A. Tools and consumable materials
- Cap extractor ARNOULD 02-905
- Bulb extractor ARNOULD 02-906
B. Procedure
1) Make sure that the main switch-breaker is open.
2) If installed, remove the instrument panel cover :
a) Remove the lighting rheostat knobs.
b) Remove the cover attachment clips.
c) Remove the instrument panel cover.
3) Remove the cap with the extractor ARNOULD 02-905.
4) If necessary, remove the bulb with the extractor ARNOULD 02-906.
NOTE : The installation operations do not require special procedures.
AAAA
Validity : S / N 1 - 9999 31-50-01Page 301
(BA) SEP 02
PAGE INTENTIONALLY LEFT BLANK
AAAA
Validity : S / N 1 - 9999 31 50 01 Page (BA) SEP 302
ADVISORY PANEL
REMOVAL / INSTALLATION
1. REMOVAL OF ADVISORY PANEL (Figure 401)
A. Tools and consumable materials
None
B. Procedure
1) Make sure that the main switch-breaker is open.
2) Remove screws (10) and (14) and washers (11) and (13). Clear upholstery panel (12).
3) Unlock and tilt instrument panel (1) - refer to 31-10-01.
4) Remove the instruments located on the upper section of the instrument panel.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 31 指示/记录系统 TB20飞机维护手册(18)
| 
