曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
3) Attach battery relay (8) with bolts (5) and washers (6). 4) Connect battery relay (8). 5) Apply a layer of varnish (TB 07-901) on the electric connections. 6) Connect the battery - refer to 24-30-02. 7) Install the cowling under hull 218A. 8) Perform a test run-up - refer to 05-30-02. Battery relay - Removal / Installation Figure 401 BATTERY RELAY REMOVAL / INSTALLATION 1. REMOVAL OF THE BATTERY RELAY (Figure 401) A. Tools and consumable materials None B. Procedure CAUTION : BEFORE ANY OPERATION, MAKE SURE THAT THE BATTERY AND ANY GROUND POWER SUPPLY ARE DISCONNECTED. 1) Disconnect the battery - refer to 24-30-02. 2) Remove engine cowling 121 - refer to 71-10-01. CAUTION : BEFORE DISCONNECTING THE BATTERY RELAY, MARK THE CONNECTIONS, ESPECIALLY THOSE OF DIODES (5) AND (6). 3) Disconnect battery relay (4). 4) Remove battery relay (4). Retain bolts (7) and washers (8). 2. INSTALLATION OF THE BATTERY RELAY (Figure 401) A. Tools and consumable materials - Varnish (TB 07-901) - Petrolatum (TB 04-012) B. Procedure 1) Check and replace, if necessary, the protection boots installed at the level of the connections. 2) Check skin condition under battery relay attachments. In order to provide a correct electrical grounding, apply a thin layer of petrolatum (TB 04-012) under mounting pads (9). 3) Attach battery relay (4) with bolts (7) and washers (8). 4) Connect battery relay (4). 5) Apply a layer of varnish (TB 07-901) on the electric connections. 6) Connect the battery - refer to 24-30-02. 7) Install engine cowling 121 - refer to 71-10-01. 8) Perform a test run-up - refer to 05-30-02. 1 - Battery 2 - Ground power receptacle relay 3 - Starter relay 4 - Battery relay 5 - Diode 6 - Diode 7 - Bolt 8 - Washer 9 - Mounting pad 14243003AAADWZ4100 Battery relay - Removal / Installation |