曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
"CONCORDE AIRCRAFT BATTERY" manual. 9) Open the switch-breakers of taxi and landing lights. 10) Shut down the engine - refer to 05-30-02. ABAB Validity : With front battery 24-30-02Page 601 (CA) OCT 02 PAGE INTENTIONALLY LEFT BLANK ABAB Validity : With front battery 24-30 0 _ Page 602 2 (CA) OCT 02 BATTERY RELAY REMOVAL / INSTALLATION 1. REMOVAL OF THE BATTERY RELAY (Figure 401) A. Tools and consumable materials None B. Procedure CAUTION : BEFORE ANY OPERATION, MAKE SURE THAT THE BATTERY AND ANY GROUND POWER SUPPLY ARE DISCONNECTED. 1) Disconnect the battery - refer to 24-30-02. 2) Remove the cowling under hull 218A. CAUTION : BEFORE DISCONNECTING THE BATTERY RELAY, MARK THE CONNECTIONS, ESPECIALLY THOSE OF DIODE (3). 3) Disconnect battery relay (4). 4) Remove battery relay (4). Retain bolts (1) and washers (2). 2. INSTALLATION OF THE BATTERY RELAY (Figure 401) A. Tools and consumable materials - Varnish (TB 07-901) - Petrolatum (TB 04-012) B. Procedure 1) Check and replace, if necessary, the protection boots installed at the level of the connections. 2) Check skin condition under battery relay attachments. In order to provide a correct electrical grounding, apply a thin layer of petrolatum (TB 04-012) under mounting pads (7) and under ground (5). 3) Attach battery relay (4) with bolts (1) and washers (2). 4) Connect battery relay (4). 5) Apply a layer of varnish (TB 07-901) on the electric connections. 6) Connect the battery - refer to 24-30-02. 7) Install the cowling under hull 218A. 8) Perform a test run-up - refer to 05-30-02. ACAA Validity : S / N 1 - 822, 850 - 887, 889 - 947 Page 401 24-30-03 (CA) OCT 02 |