曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
- box around the battery, - discharge fitting, - tray attachments, - grommets, replace them if necessary, 2) If removed, install tray (6) - refer to 24-30-04. 3) Protect, if necessary, tray (6) interior with protection product (TB 05-918). 4) Using the battery strap, install battery (8) into its tray (6). 5) Position lugs (4) and (5). ADAB Validity : With front battery 24-30-02Page 401 (DG) OCT 02 6) Lubricate lugs with petrolatum (TB 04-012). 7) Install cover (2) and lock it. 8) Install inspection door (1) 211R. ADAB Validity : With front battery 24_30_02L Page 402 (DG) OCT 02 Battery - Removal / Installation Figure 401 ADAB Validity : With front battery 24 30-02Page 403 (DG) OCT 02 PAGE INTENTIONALLY LEFT BLANK ADAB Validity : With front battery 24-30-02 Page 404 (DG) OCT 02 BATTERY INSPECTION / CHECK 1. CHECK OF THE BATTERY A. Tools and consumable materials None B. Procedure 1) Perform a test run-up - refer to 05-30-02. 2) If connected, disconnect the ground power unit - refer to 24-40-00. 3) Once the different engine parameters have stabilized, open the battery switch-breaker. 4) Close the switch-breakers of taxi and landing lights. 5) Reduce the engine rating to idle. 6) Close the battery switch-breaker. 7) Increase the engine rating to 1500 rpm approximately. 8) Check that the indication of the engine monitoring cluster voltmeter stabilizes inside the green sector. NOTE : If the voltmeter is in lower red sector, remove and charge the battery. 9) Open the switch-breakers of taxi and landing lights. 10) Shut down the engine - refer to 05-30-02. WA Validity : S / N 1 - 9999 24-30-02Page 601 (BA) OCT 02 PAGE INTENTIONALLY LEFT BLANK AAAA Validity : S / N 1 - 9999 24-30-02 Page 602 24 (BA) OCT 02 BATTERY INSPECTION / CHECK 1. CHECK OF THE BATTERY A. Tools and consumable materials None B. Procedure 1) Perform a test run-up - refer to 05-30-02. 2) If connected, disconnect the ground power unit - refer to 24-40-00. 3) Once the different engine parameters have stabilized, open the battery switch-breaker. 4) Close the switch-breakers of taxi and landing lights. 5) Reduce the engine rating to idle. 6) Close the battery switch-breaker. 7) Increase the engine rating to 1500 rpm approximately. 8) Check that the indication of the engine monitoring cluster voltmeter stabilizes inside the green sector. NOTE : If the voltmeter is in lower red sector, remove and charge the battery. Refer to 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址:TB20 MAINTENANCE MANUAL 24 COMMUNICATIONS TB20飞机维护手册 电源(34) |