返回首页
当前位置: 主页 > 通航资料 > TB >

TB20 MAINTENANCE MANUAL 71 动力装置 TB20飞机维护手册(26)

时间:2011-11-11 10:08来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
  
2. INSTALLATION OF AIR INTAKE BOX (Figure 401)
A. Tools and consumable materials
- Lubricant (TB 06-903)
- Stainless steel lockwire, dia. 0.024 in (0.6 mm)
- Grease (TB 04-004A)
B. Procedure
1) Check air intake box (9) and filter assy (14) for shock marks, cracks and corrosion.
2) Operate the shutter and check for correct operation. Check the seal for correct condition.
AEAC
Validity : With "Alternate Air" control 71-60-00Page 401
(FA) J UN 02
 
3) Check air filter (15) for condition and cleanliness, replace it if necessary.
4) Check gasket (1) for condition, replace it if necessary.
5) Lubricate the shutter seal and hinge pin - refer to 12-21-01.
CAUTION : IN CASE OF SELF-LOCKING BOLTS (8) (POLYAMIDE DEPOSIT ON THE THREADS), INSTALL NEW BOLTS EVERY 5 AIR INTAKE BOX REINSTALLATIONS OR IF THE BOLTS CAN BE FULLY SCREWED BY HAND.
6) Remove the blanking cap, position gasket (1), air intake box (9), reinforcement plate (21) (if installed) on the injection pump. Install bolts (8) and washers (7) (if necessary).
NOTE : If reinforcement plate (21) is installed, there are no washers (7).
NOTE : Position reinforcement plate (21) with the 45° chamfer towards the top of the box - see Detail A.
With lockwired bolts (8)
7) Lockwire bolts (8).
All
8) Align strut (2) with the box, then install bolt (3) equipped with washer (4), washer (5) and new nut (6).
9) Secure filter assy (14) to the box using bolts (13), washers (12) and (11) and new nuts (10).
10) Install air filter (15) and grid (17). Secure with washers (19) and screws (18).
NOTE : Make sure grid (17) touches rapid nuts (16) to prevent box wear.
11) Connect the Alternate Air control - refer to 76-10-05.
12) Make sure all the tools and materials are removed and the work area is clean and free from debris.
13) Install the engine cowlings - refer to 71-10-01.
AEAC
Validity : With "Alternate Air" control 71-60-00Page 402
(FA) JUN 02
 
10 - Nut
11 - Washer
12 - Washer
13 - Bolt
14 - Filter assy
15 - Air filter
16 - Rapid nut
17 - Grid
18 - Screw
19 - Washer
20 - Additional air filter
21 - Reinforcement plate
 
®
Chanfrein Chamfer
r isliv A
'WI
21
 

 
19
 

 
15 J 14 13 — 12
Air intake box - Removal / Installation
Figure 401
 
AEAC
Validity : With "Alternate Air" control 71 60-00Page 403
(FA) JUN 02
 
PAGE INTENTIONALLY LEFT BLANK
AEAC
Validity : With "Alternate Air" control 71-60-00Page 404
(FA) JUN 02
 
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址:TB20 MAINTENANCE MANUAL 71 动力装置 TB20飞机维护手册(26)
 

------分隔线----------------------------