曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
14) Remove the blanking caps and connect alternator cooling hose (31). Tighten the clamp. CAUTION : BE CAREFUL NOT TO PEEL THE PROTECTIVE SLEEVE OF THE IGNITION HARNESSES. 15) Route the ignition harnesses through R.H. side bulkhead (27) and L.H. side bulkhead (56). 16) Install and attach grommets (24) with bolts (25), washers (23) and new nuts (22). 17) Secure strut (54) to the power plant using screw (50), new lockwasher (51), washer (52), clamp (53) and spacer (55). Tighten nut (49). 18) Connect the power plant ignition harnesses - refer to 74-20-01. 19) Install the ignition harness holding clamps on the bulkheads and the power plant upper section. 20) Mark the hoses/tubes and unions with a red paint line. 21) Install the oil coolers - refer to 79-20-01. 22) Connect the propeller governor control - refer to 61-20-02. 23) Make sure all the tools and materials are removed and the work area is clean and free from debris. 24) Install the engine cowlings - refer to 71-10-01. 25) Perform a test run-up - refer to 05-30-02. ADAB Validity : With additional oil cooler 71-10-02 (Em) Page 404 JUN 02 PAGE INTENTIONALLY LEFT BLANK ADAB Validity : With additional oil cooler 71-10-02 (EM) Page 405 JUN 02 1 - Nut 2 - Washer 3 - Washer 4 - Silent-block 5 - Strut 6 - Washer 7 - Nut 8 - Bolt 9 - R.H. rear bulkhead 10 - Washer 11 - Lockwasher 12 - Screw 13 - Washer 14 - Bolt 15 - Clamp 16 - Spacer 17 - Central rear bulkhead 18 - Washer 19 - Nut 20 - Extension 21 - Spring 22 - Nut 23 - Washer 24 - Grommet 25 - Bolt 26 - Spacer 27 - R.H. side bulkhead 28 - Washer 29 - Lockwasher 30 - Screw 31 - Alternator cooling hose 32 - R.H. front bulkhead 33 - Screw 34 - Lockwasher 35 - Washer Engine bulkheads - Removal / Installation Key to Figure 401 (1/2) - Pre-MOD. 105 or Kit OPT10 923200 ADAB Validity : With additional oil cooler 71-10-02 (E.) Page 406 JUN 02 Engine bulkheads - Removal / Installation Figure 401 (1/2) - Pre-MOD. 105 or Kit OPT10 923200 ADAB Validity : With additional oil cooler 71-10-02(EM) Page 407 JUN 02 1 - Nut 2 - Washer 3 - Washer 4 - Silent-block 5 - Strut 6 - Washer 7 - Nut 8 - Bolt 9 - R.H. rear bulkhead 11 - Lockwasher 12 - Screw 13 - Washer 14 - Bolt 15 - Clamp 16 - Spacer 17 - Central rear bulkhead 18 - Washer 19 - Nut 20 - Extension 21 - Spring 22 - Nut 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址:TB20 MAINTENANCE MANUAL 71 动力装置 TB20飞机维护手册(18) |