|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
CAUTION : DO NOT HANDLE FLASH TUBE ASSY (7) DIRECTLY WITH FINGERS. ALWAYS USE A CLEAN CLOTH. c) Position grommet (15) correctly on support (4), position flash tube assy (7) in its housing. d) Make sure gaskets (3) and (13) are present and in correct condition, install domes (6), (10) and (11), install lens retainer (8) and secure with screws (9). NOTE : Dome (11) is green for the R.H. light and red for the L.H. light. e) Bind the leads with tie-wraps. f) Make sure all the tools and materials are removed and the work area is clean and free from debris. g) Install the wing tip - refer to 57-30-00. 2) Install navigation light bulb CAUTION : DO NOT HANDLE BULB (5) DIRECTLY WITH FINGERS. ALWAYS USE A CLEAN CLOTH. a) Install bulb (5) or (12). b) Inspect gaskets (3) and (13) for condition. AAAA Validity : Post-MOD. 151 33-40-02Page 402 (BA) SEP 04 c) Install domes (6), (10) and (11). NOTE : Dome (11) is green for the R.H. light and red for the L.H. light. d) Install lens retainer (8), secure with screws (9). 3) Install light assy a) Inspect the interfaces for cleanliness and condition. b) Position and secure the light assy into the wing tip with screws (14) coated with loctite (TB 08-013C). NOTE : If the light is replaced, unscrew knurled knob (16) before routing the leads through the smallest orifice of the wing tip. c) Install domes (6), (10) and (11), install and secure lens retainer (8) with screws (9). NOTE : Dome (11) is green for the R.H. light and red for the L.H. light. d) Tighten knurled knob (16) onto the light assy. e) Apply a bead of sealant (TB 09-002A) around the light assy. f) Make sure all the tools and materials are removed and the work area is clean and free from debris. g) Install the wing tip - refer to 57-30-00. 4) Remove the warning sign prohibiting main switch-breaker operation. 5) Perform an operational test of anticollision and navigation lights - refer to Page 501. WA Validity : Post-MOD. 151 33 40-02Page 403 (BA) SEP 04 1 - Connector 2 - Connector 3 - Gasket 4 - Support 5 - Bulb 6 Dome 7 - Flash tube assy 8 - Lens retainer 9 - Screw 10 - Dome 11 - Dome 12 - Bulb 13 - Gasket 14 - Screw 15 - Grommet 16 - Knurled knob Anticollision and navigation lights - Removal / Installation Figure 401 AAAA Validity : Post-MOD. 151 33-40-02Page 404 (BA) SEP 04 ANTICOLLISION AND NAVIGATION LIGHTS ADJUSTMENT / TEST 1. OPERATIONAL TEST OF ANTICOLLISION AND NAVIGATION LIGHTS A. Tools and consumable materials - Ground power unit B. Procedure 1) If required, connect the ground power unit - refer to 24-40-00. 中国通航网 www.ga.cn 通航翻译 www.aviation.cn 本文链接地址：TB20 MAINTENANCE MANUAL 33 灯光 TB20飞机维护手册(14) |
