曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
A switch, located on the circuit-breaker panel, controls the strobe light illumination. This circuit is protected by a circuit-breaker located on the left of the switch.
The L.H. wing leading edge light switch is located on de-icing system control panel, on R.H. or L.H. strip or on radio rack.
AEAB
Validity : Post-MOD. 151 33-40-00Page 3
(DA) SEP 04
1 - Adjustment screw
2 - Landing light
3 - Taxi light
4 - Spring
5 - Wing leading edge light
2
14334001AAABYZ4000 1
Landing and taxi lights
Figure 1
AEAB
Validity : Post-MOD. 151 33-40 Page 4
00 (DA) SEP 04
1 - A31 anticollision lights power unit
2 - Anticollision and navigation lights
3 - Recognition lights (Option)
14334002AAAAYZ4100
Anticollision and navigation lights
Figure 2
AEAB
Validity : Post-MOD. 151 33-40-00Page 5
(DA) SEP 04
1 - Fin strobe light (Option)
2 - A33 strobe light power unit
Fin strobe light (Option)
Figure 3
AEAB
Validity : Post-MOD. 151 33 40-00Page 6
(DA) SEP 04
PAGE INTENTIONALLY LEFT BLANK
AEAB
Validity : Post-MOD. 151 33-40-00Page 8
(DA) SEP 04
TAXI AND LANDING LIGHTS
REMOVAL / INSTALLATION
1. REMOVAL OF THE LIGHTS (Figure 401)
A. Tools and consumable materials
None
B. Procedure
1) Make sure that the main switch-breaker is open.
2) Make sure taxi light and landing light switch-breakers are open.
3) Install the warning sign prohibiting main switch-breaker operation.
WARNING
DO NOT OPERATE
MAINTENANCE WORK IN PROGRESS
4) Remove screws (6), washers (7) and lens (8).
5) Remove screws (12), washers (13) and cover (11).
NOTE : On some versions, the cover is integral with the lens.
6) Hold the light, remove both springs (16), remove screws (14) and washers (15) securing wires (2).
7) Clear and remove the light.
2. INSTALLATION OF THE LIGHTS (Figure 401)
A. Tools and consumable materials
- Varnish (TB 07-901)
B. Procedure
1) Secure wires (2) with screws (14) and washers (15) on the rear face of the light.
NOTE : Lock the screws with varnish (TB 07-901).
2) Position the light against support (5) while paying attention to foolproof device (1), secure with
springs (16).
3) Perform an operational test of the lights.
4) Make sure all the tools and materials are removed and the work area is clean and free from debris.
5) Remove the warning sign prohibiting main switch-breaker operation.
6) Install cover (11) and lens (8).
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 33 灯光 TB20飞机维护手册(11)
|
