|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
1) Check ring (10) and drive shaft (13) for condition and play. 2) If necessary, unblock evacuation hole (5) located beneath drive (16) section. 3) Lubricate drive shaft (13) and driving gear (15) - refer to 12-21-01. 4) Check boot (4) for correct condition. Replace if necessary. 5) Install and secure starter (17) with washers (6), new lockwashers (7) and nuts (9). 6) Install washer (6), new lockwasher (7) and bolt (8). 7) Torque nuts (9) and bolt (8) - refer to 20-00-01. 8) Secure alternator link rod (14) with bolt (12) and washer (11). Lockwire bolt (12). 9) Connect power supply cable (1) with a new lockwasher (2) and nut (3). Torque - refer to 20-00-01. 10) Protect the connection with boot (4). 11) Make sure alternator wiring (18) does not touch engine (30) between alternator (31) and starter (17). 12) Secure alternator wiring (18) on the body of starter (17) with a new tie-wrap (19). With vapor cycle cooling 13) Install L40 compressor - refer to 21-55-01. All 14) Make sure all the tools and materials are removed and the work area is clean and free from debris. 15) Install the engine cowlings - refer to 71-10-01. 16) Perform a test run-up - refer to 05-30-02. PAGE INTENTIONALLY LEFT BLANK AEAC Validity : "ELECTROSYSTEMS MHB - 6016" starter 80-00-01Page 403 (CG) SEP 04 1 - Power supply cable 2 - Lockwasher 3 - Nut 4 - Boot 5 - Evacuation hole 6 - Washer 7 - Lockwasher 8 - Bolt 9 - Nut 10 - Ring 11 - Washer 12 - Bolt 13 - Drive shaft 14 - Alternator link rod 15 - Driving gear 16 - Drive 17 - Starter 18 - Alternator wiring 19 - Tie-wrap Starter - Removal / Installation Key to Figure 401 AEAC Validity : "ELECTROSYSTEMS MHB - 6016" starter 80-00-01Page 404 (CG) SEP 04 Starter - Removal / Installation Figure 401 AEAC Validity : "ELECTROSYSTEMS MHB - 6016" starter 80-00-01Page 405 (CG) SEP 04 17 - Starter 18 - Alternator wiring 19 - Tie-wrap 30 - Engine 31 - Alternator ® |
