曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
14550000AAACWZ14101 Vertical stabilizer - Identification and location of components
Figure 1
ABAA
Validity : S / N 1 - 9999 55-30 00Page 2
(CA) SEP 04
VERTICAL STABILIZER
REMOVAL / INSTALLATION
1. REMOVAL OF THE VERTICAL STABILIZER (Figure 401)
A. Tools and consumable materials
- Padded supports
- 1 padded support for frame C8
B. Procedure
1) Remove baggage compartment bottom door 242. Post-MOD. 151
2) Remove dorsal fin 225.
S / N 1 - 9999
CAUTION : THE SUPPORT MUST FIT TO FUSELAGE PROFILE PERFECTLY AND BEARING
FACES MUST BE PADDED TO AVOID DAMAGING THE STRUCTURE.
3) Put the padded support under rear fuselage at frame C8.
4) Protect the baggage compartment bottom area in order to gain access to the fuselage rear section, particularly to frames C7 (1) and C8 (2).
5) Remove the rudder - refer to 55-40-00.
6) If necessary, remove tail cone - refer to 53-20-04.
7) If installed, disconnect the anti-collision light connector and the GLIDE and VOR / LOC antennas.
8) Remove bolts (9) and washers (8) securing vertical stabilizer front attachment (7) to frame C7 (1).
9) Hold the vertical stabilizer, remove bolts (4) and washers (5) securing vertical stabilizer spar (6) to frame C8 (2).
10) Disengage the vertical stabilizer and place it on two padded supports.
2. INSTALLATION OF THE VERTICAL STABILIZER (Figure 401)
A. Tools and consumable materials
- Torque wrench (0 - 266 lbf.in) (0 - 30 N.m)
- Red paint
B. Procedure
1) If installed, inspect the anti-collision light electrical cable and connector for condition. Inspect the anti-collision light bulb and glass for condition and attachment.
2) If installed, inspect the antennas and coaxial cables for condition.
3) Position the vertical stabilizer.
4) Hold the vertical stabilizer and secure vertical stabilizer spar (6) to frame C8 (2) with bolts (4) and washers (5). Torque - refer to 20-00-01.
ABAA
Validity : S / N 1 - 9999
Page 401
55-30-00
(CA) SEP 04
5) Secure vertical stabilizer front attachment (7) to frame C7 (1) with bolts (9) and washers (8). Torque
refer to 20-00-01.
6) Mark bolts (4) and (9) with a red paint line.
7) If installed, connect the anti-collision light connector and the GLIDE and VOR / LOC antennas.
8) Remove the protection from the baggage compartment bottom area.
9) Make sure all the tools and materials are removed and the work area is clean and free from debris.
10) Remove the padded support.
11) Install baggage compartment bottom door 242.
Post-MOD. 151
12) Install dorsal fin 225.
S / N 1 - 9999
13) If removed, install tail cone - refer to 53-20-04.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 55 安定面 TB20飞机维护手册(9)
|
