|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
1) Remove the blanking caps. 2) Remove plastex or loctite from cooler (1) ports. Rinse the latter with cleaning agent (TB 11-003) and dry it. 3) Position cooler on engine bulkhead (10) and secure it with the four threaded rods (5), washers (6), spacers (9) and new nuts (4). 4) If removed, install elbows (2). a) Clean and degrease elbows (2) and coat the thread with loctite (TB 09 -906). b) Position elbows (2) on cooler (1 ) , hand-tighten up to contact. c) Hold ends (8) using a thin spanner and tighten elbows (2). NOTE : Orientate lower elbow (2) 10° downwards so that hose (7) does not come into contact with the engine mount. 5) Hold elbows (2) using a thin spanner to avoid any distortion of cooler (1) fins - see Details A and B, when tightening hoses (3) and (7) on elbows. Torque - refer to 20-00-01. 6) Mark ends (8), elbows (2) and hoses (3) and (7) with a red paint line. 7) Install the standard oil cooler- refer to Paragraph 2. 8) Install the engine cowlings - refer to 71-10-01. 9) Fill the oil system - refer to 12-12-01. 10) Check for leaks. ABAB Validity : S /N 1 - 1822,1824,1825,1827 - 1842 Pre-Kit OPT10 923500 79_20-01 Page 403 (DA) SEP 02 1 - Cooler 2 - Elbow 3 - Hose 4 - Nut 5 - Threaded rod 6 - Washer 7 - Hose 8 - End 9 - Spacer 10 - Engine bulkhead Standard cooler - Removal / Installation |
