|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
8.5 GROUND HANDLING / ROAD TRANSPORT
8.5.1 GROUND HANDLING
For pushing or pulling the airplane on the ground, it is recommended to use the tow bar which is available from the manufacturer. The tow bar is engaged in the appropriate hole in the nose wheel as shown on the picture.
Tow bar
WARNING
The tow bar must be removed before starting the engine.
CAUTION
The tow bar may only be used for moving the airplane on the ground by hand. After moving the airplane, the tow bar must be removed.
CAUTION
Towing with towing vehicles is not approved.
8.5.2 PARKING
For short term parking, the airplane must be positioned into the wind, the parking brake must be engaged and the wing flaps must be in the retracted position. For extended and unattended parking, as well as in unpredictable wind conditions, the airplane must be anchored to the ground or placed in a hangar. Parking in a hangar is recommended.
Control surfaces gust lock
The manufacturer offers a control surfaces gust lock which can be used to block the primary controls. It is recommended that the control surfaces gust lock be used when parking outdoors, because otherwise the control surfaces can hit the stops in strong tail wind. This can lead to excessive wear or damage.
WARNING
The control surfaces gust lock must be removed before flight.
The control surfaces gust lock is installed as follows:
1.
Move the rudder pedals fully forward.
2.
Engage the control surfaces gustlock with the pedals.
3.
Engage the stick, wrap straps around stick once.
4.
Attach the locks and tighten the straps.
For removal reverse the sequence.
8.5.3 MOORING
Near the lower end of the tail fin of the airplane there is a hole which can be used to tie down the airplane to the ground. Also on each wing near the wing tip, an eyelet with a metric M8 thread can be installed and used as tie-down points.
8.5.4 JACKING
The airplane can be jacked at the two jackpoints located on the lower side of the center wing's LH and RH root ribs as well as at the tail fin.
8.6 CLEANING AND CARE
CAUTION
The airplane must be kept clean. The bright surface prevents the structure from overheating.
CAUTION
Excessive dirt deteriorates the flight performance.
8.6.1 PAINTED SURFACES
The entire surface of the airplane is painted with a white weatherproof two component paint. Nevertheless, it is recommended to protect the airplane against moisture and dampness. It is also recommended not to store the airplane outside for long periods of time.
Dirt, insects, etc. can be removed with water alone and if necessary with a mild detergent. An automotive paint cleaner can be used for stubborn spots. For best results, clean the airplane after the day's flying is ended, so that the dirt will not become ingrained.
中国通航网 www.ga.cn
通航翻译 www.aviation.cn
本文链接地址：钻石40系列飞机维护手册 DA 40 SERIES AIRPLANE MAINTENANCE MANUAL 4(38)
| 
