|
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
2. REMOVAL / INSTALLATION — TACHOMETER SENSOR (Figure 201) A. Tools and consumable materials — Loctite (TB 08-013C) — Tie—wraps — Torque wrench 0 — 177 lbf.in (0 — 20 N.m) B. Removal of the tachometer sensor WARNING : PRIOR TO ANY OPERATION, ENSURE THAT THE ENGINE, EXHAUST PIPE AND MANIFOLDS ARE COLD. IF NOT, TAKE NECESSARY PRECAUTIONS TO AVOID SEVERE BURNS. WARNING : PRIOR TO ANY OPERATION, ENSURE THAT THE KEY IS REMOVED FROM MAGNETO SELECTOR AND THAT "MAIN SWITCH" IS OFF. 1) Remove engine cowling 121 — refer to 71-10-01. 2) Disconnect the battery — refer to 24-30-02. 3) Cut tie—wraps (1). 4) Disconnect connector (2). 5) Unlock and remove nut (8), lockwasher (7) and sensor (5). Discard lockwasher (7). 6) If necessary, remove nuts (3), washers (4), bolts (10), washers (11) and bracket (6). C. Installation of the tachometer sensor 1) If removed, position bracket (6) and attach it with bolts (10) coated with loctite (TB 08-013C), washers (4) and (11) and nuts (3). 2) Torque — refer to 20-00-01. 3) Screw sensor (5) on bracket (6). 4) Install new lockwasher (7) and nut (8). Do not tighten. 5) Adjust the sensor — refer to Paragraph 3. 6) Lock nut (8) by folding down lockwasher (7). 7) Connect connector (2). 8) Attach connector (2) and wiring with tie—wraps (1). 9) Connect the battery — refer to 24-30-02. 10) Install engine cowling 121 — refer to 71-10-01. I ABAA Validity : S / N 823 — 849, 888, 948 — 9999 age 201 77-10-01 (.„„ P JUL 99 II 1 — Tie—wrap 2 — Connector 3 — Nut 4 — Washer 5 — Sensor 6 — Bracket 7 — Lockwasher 8 — Nut 9 — Starter ring 10 — Bolt 11 — Washer |
